CN
CN EN
CN EN
英文版网站

Product Center

Saliva Multi-Drug Test Panel
Saliva Multi-Drug Test Panel
The Saliva Drug of Abuse test is a lateral flow chromatographic immunoassay for the qualitative detection of multiple drugs and drug metabolites in saliva specimen at specified cut-off level. 
Contact us
Product Information
INTENDED USE:
The saliva drug test kit is a lateral flow chromatographic immunoassay for the qualitative detection of multiple drugs and drug metabolites in saliva at the following cut-off concentrations.
TEST PROCEDURE:
Allow the test kit to reach room temperature (15-30℃)prior to testing.Do not place anything in the mouth
including food,drink,gum,or tobacco products for at least 10 minutes prior to collection of saliva specimen.
1.Bring the pouch to room temperature before opening it. Remove the test from the sealed pouch and use it as
soon as possible.
2.Remove the collector from the sealed pouch.Insert the sponge into the mouth.Close mouth and move the sponge around for saliva collection.Soak sponge in saliva and swab the inside of the mouth and tongue. Collect saliva for 3 minutes until sponge is soft and fully saturated.The sponge will be free from hard spots when saturated.
3.Place the test kit on a clean and level surface.Hold the collector upright and insert the sponge into the specimen
well of the test kit.Use the thumb and index finger to squeeze the sponge till red colored liquid appear.
4.Read results within 3 to 8 minutes.Do not read result after 10 minutes.
INTERPRETATION OF RESULTS
NEGATIVE:
One colored line appears in the control region(C),one colored line apears in the corresponding drug test region(T).
This negative result indicates that the drug concentration is below the detectable level.
*NOTE:The shade of color in the test line region(T)will vary,but it should be considered negative whenever there is
even a faint distinguishable color line.
POSITIVE:
One colored line appears in the control region (C).No line appears in the corresponding dug test region(T).This
positive result indicates that the drug concentration is above the detectable level.
INVALID:
Control line fails to appear.Insufficient specimen volume or incorrect procedural techniques are the most likely reasons
for control line failure.Review the procedure and repeat the test using a new test kit.If the problem persists,stop using
the lot immediately and contact your supplier.
SPECIFICATION:   
Product Name Specimen Format Catalog No. Sensitivity Package Size Strip Width Certificate
(MOP)Morphine Saliva Test Saliva Cassette D01-S20 15ng/mL 8 Tests 4.0mm ——
(MET)Methamphetamine Saliva Test D02-S20 50ng/mL
(KET)Ketamine Saliva Test D03-S20 100ng/mL
(MDMA)Ecstasy Saliva Test D04-S20 60ng/mL
(COC)Cocaine Saliva Test D05-S20 50ng/mL
(THC)Marijuana Saliva Test D06-S20 30ng/mL
(AMP)Amphetamine Saliva Test D07-S20 50ng/mL
(MTD)Methadone Saliva Test D10-S20 30ng/mL
Multi-Drug 2 Saliva Test Panel Multi-Panel D100-S40 —— 20 Tests 4.0mm
Multi-Drug 3 Saliva Test Panel D110-S40 —— 20 Tests 4.0mm
Multi-Drug 5 Saliva Test Panel D120-S40 —— 20 Tests 4.0mm
 
 
 
 


Return